Experimental studies of particle formation from solution droplets were conducted using a
newly developed monodisperse spray drying process. Solutes beclomethasone …

The effects of propellant type, cosolvent content, and air humidity on the morphology and
solid phase of the particles produced from solution pressurized metered dose inhalers …

A new low-flow-rate (0.5 L/min) single-nozzle impactor for the concentration of dilute aerosol
particles with selected pharmaceutical applications is described in this paper. The impactor …

The addition of a small amount of high molecular weight polymer to a solvent can
substantially decrease friction losses by approximately 80%. This phenomenon known as …

RESULTS The purpose of this work was to evaluate the effects of formulation parameters
(solution concentration, cosolvent content) and process parameters (initial droplet diameter …

Three different polysaccharides, aloe vera, Tamarind powder and pineapple fibers, are
utilized as drag reducing agents in a turbulent flow. Using a Taylor–Couette setup …

Turbulent drag reduction with high molecular weight polymers is examined experimentally
using Taylor-Couette (TC) flow set-up. The set-up consisted of a rotating inner cylinder and a …

Objective The only pharmacologic prophylaxis for cerebral vasospasm after subarachnoid
hemorrhage is oral nimodipine. A novel way to mitigate this risk may be to design a drug …

Pallavi Bhambri Page 1 Drag reduction using additives in a Taylor-Couette Flow by Pallavi
Bhambri A thesis submitted in partial fulfillment of the requirements for the degree of Master of …

In the present study, experiments were conducted in a rectangular mixing conduit of an
effervescent atomizer to quantify the effect of addition of drag reducing agent on bubble …